Bulletpoint Locking Adjustable Carbon Fibre Kevlar Mounting Arm — Dual 20mm Sockets, 7cm-to-7cm, 9 Lock Positions

Built from carbon fiber reinforced with Kevlar, this 7cm-to-7cm articulating mounting arm delivers strong, stiff support with minimal weight. It uses two 7cm segments connected by a locking articulating elbow that rotates up to 90° in each direction, and aluminum connector ends sized for 20mm ball mounts so it integrates seamlessly with Bulletpoint device holders and accessories.

How does the articulating joint improve positioning?

The central articulating elbow gives you repeatable, lockable angles so you can set and maintain a specific orientation under load. Its design balances smooth motion for adjustment with positive lock points for stability.

• Nine distinct adjustment positions across the elbow for consistent setups
• 90° range of motion in each direction for wide angle selection
• Positive-lock mechanism to resist slippage once set
• Compact 7cm arms reduce leverage while preserving reach and control

Will this arm fit my Bulletpoint device holders and accessories?

Yes—both ends use a 20mm socket size designed to mate with Bulletpoint’s ecosystem of ball-based holders and mounts. The aluminum socket connectors provide a precise interface that works with compatible balls and clamps.

• Dual 20mm socket ends match Bulletpoint ball-joint accessories
• Aluminum connector ends for dimensional accuracy and wear resistance
• Direct compatibility with Bulletpoint holders, clamps, and plates
• Ideal as a middle link between two mounting elements or as an adjustable arm for a single holder

How durable and lightweight is the carbon fiber + Kevlar construction?

The arm combines carbon fiber’s stiffness with Kevlar’s impact resistance to produce a part that’s both rigid and tough without adding bulk. The result is an arm that supports devices reliably while keeping weight low—useful where both strength and minimal mass matter.

• Carbon fiber body for high stiffness-to-weight ratio
• Kevlar reinforcement to improve abrasion and impact resistance
• Aluminum sockets for secure connector interfaces
• Low overall weight reduces load on clamps and mounting points

What adjustments and limits should I expect during use?

The arm’s nine-lock positions let you fine-tune angles, but its compact 7cm-to-7cm layout imposes modest reach compared with longer arms. It’s intended for moderate loads and precise placement rather than heavy structural support.

• Nine locking positions for repeatable orientation
• Maximum 90° articulation each direction from center position
• Recommended for lightweight to medium-weight devices and accessories
• Short 7cm arms keep leverage low for stable setups

Who this is for: The Bulletpoint Locking Adjustable Carbon Fiber Kevlar Mounting Arm is aimed at photographers, videographers, audio engineers, and makers who need a compact, precise articulating link that integrates with Bulletpoint ball-mount gear. Choose this arm when you want a lightweight, stiff connector to position cameras, monitors, lights, or sensors in tight spaces where repeatable angles and low mass are priorities.