Cxdar LED Third Brake Light for 2003–2016 Ford Expedition & Lincoln Navigator — Black, Waterproof High‑Mount Stop Lamp

The Cxdar Third 3rd Brake Light is a direct-fit, waterproof LED high‑mount stop lamp designed to replace the factory center brake light on 2003–2016 Ford Expedition and 2003–2016 Lincoln Navigator models.

This aftermarket high‑mount brake lamp combines a low‑power LED array with an ABS housing and sealed gasket for reliable road use. It installs with the factory wiring harness for a plug‑and‑play swap and restores the center stop light function after damage, wear, or upgrade. Built to withstand wet conditions and everyday driving, the Cxdar assembly brings consistent illumination and a refreshed appearance to older SUVs.

Will this brake light fit my 2003–2016 Ford Expedition or Lincoln Navigator?

Yes — the Cxdar third brake light is manufactured to match the original mounting points and electrical connector for those model years. It targets both Ford Expedition and Lincoln Navigator vehicles listed from 2003 through 2016, so it works as a direct replacement in most cases.

• Compatible with Ford Expedition model years 2003–2016.
• Compatible with Lincoln Navigator model years 2003–2016.
• Uses the factory plug for simple electrical hookup.
• Designed to match OEM mounting locations for a secure fit.

How durable and weatherproof is this center brake lamp?

The lamp features an ABS housing and a sturdy lens with a sealed gasket rated to resist water, dust, and snow exposure. The IP65-style protection helps prevent moisture intrusion and corrosion, extending the assembly's service life under typical driving conditions.

• Rugged ABS body resists cracks and impact from road debris.
• Sealed cover and gasket reduce water and dust entry.
• LED design lowers heat output and energy draw for longer life.
• Ideal for regions with rain, snow, or road spray.

How straightforward is installation, and what should I watch for?

Installation is plug‑and‑play with the factory connector, so most DIYers can complete the swap using basic tools. The manufacturer recommends not fully tightening fasteners initially to avoid stress cracking the housing; hand‑start screws and align the lamp before final torque.

• Connects to the existing OEM wiring harness—no splicing needed.
• Start screws by hand, then tighten evenly to avoid cracking.
• Hand tools are usually sufficient; professional install optional.
• Inspect bulb function before finalizing the mounting screws.

What lighting and performance benefits does this LED assembly provide?

Compared with older incandescent units, this LED high‑mount lamp uses less power while offering consistent illumination and quicker response time. The updated styling also refreshes the rear appearance and can improve visibility to drivers behind the vehicle.

• Lower electrical draw than traditional bulbs for less load on the circuit.
• Faster LED reaction time can aid in clearer signaling when braking.
• Sleek black housing modernizes the vehicle’s rear look.
• Longer expected service life under normal conditions.

Who is this for: Owners of 2003–2016 Ford Expedition or Lincoln Navigator SUVs who need a reliable, direct‑replacement center brake light—whether replacing a damaged factory lamp, updating to LED, or restoring rear visibility. It suits do‑it‑yourself installers who prefer plug‑and‑play parts as well as shops looking for a durable, weather‑resistant stop lamp to fit these specific models.