HODEE Rear Wiper Arm & Blade Kit for Chevrolet Traverse 2018-2023 — OE-fit arm, blade & hardware

HODEE's Rear Wiper Arm & Blade Kit is a complete, ready-to-install replacement for the Chevrolet Traverse (2018–2023) that restores clear rear visibility with an OE-fit arm, blade, and fasteners.

If your Traverse rear wiper is leaving streaks, skipping, or the arm is bent or corroded, this HODEE kit provides the matched arm, blade, cap, nut and a small towel so you can finish the job without extra trips to the dealer. The parts are made to match the original geometry (replacement for OE part 84148860) and are designed for a straightforward DIY swap using minimal tools.

How does the kit match my 2018–2023 Chevrolet Traverse?

The kit is built to replicate the factory rear wiper arm and blade fitment for the Chevrolet Traverse model years 2018 through 2023, replacing OE part number 84148860. HODEE engineered the attachment points and sweep arc to align with the vehicle’s rear windshield and motor spline.

• Direct fit for Traverse 2018–2023 — no trimming or modification required.
• Includes arm, blade, cap, nut and cloth for a complete swap.
• OE-equivalent geometry to preserve proper contact and wiping coverage.

What’s included and why is it useful?

This kit supplies every small component often missing from off-the-shelf blades: the wiper arm, the rear blade, the protective cap, fastening nut, and a towel to clean the glass during installation. That prevents repeat trips for missing hardware and ensures a neat finished appearance.

• Arm — replaces damaged or bent factory arm for correct alignment.
• Blade — new rubber element for reduced streaking and quieter operation.
• Cap and nut — restore the sealed, factory look and secure fit.
• Towel — helps seat the blade and leave the glass clean before test wiping.

How difficult is installation and what tools do I need?

Installation is designed for a DIY-friendly experience: the procedure is straightforward and requires only basic hand tools. Most owners can complete the swap in 10–20 minutes with minimal mechanical experience.

• Simple removal of the old arm nut and detaching the blade from the arm.
• Reinstall new arm onto the motor spline, tighten provided nut to specification.
• Snap on cap for a finished look and test the wiper through a few cycles.

Will this kit improve wiping performance?

Replacing a worn blade and a bent or loose arm typically eliminates skipping, chatter and streaking. This HODEE set restores the correct pressure profile and sweep, which leads to smoother, quieter wiping and better water removal.

• New rubber blade reduces streaks and noise during operation.
• Correct arm alignment ensures full and even contact across the glass.
• Complete fastening hardware prevents looseness that causes fluttering.

Who is this for: This kit is intended for Chevrolet Traverse owners (2018–2023) who need a direct replacement for a damaged or worn rear wiper assembly and prefer a complete, cost-effective aftermarket option over dealer parts. It’s also appropriate for DIYers, independent shops, and fleet maintainers looking to restore rear visibility quickly without sourcing multiple components.