LEDAUT Aluminized Fibreglass Heat Sleeve 1.5" I.D. x 10ft with 20 Stainless Steel Ties and Hook‑Loop Closure

This 1-1/2" inside diameter, 10-foot heat sleeve is built from high-temperature glass-fiber fabric with an aluminized outer face to reflect heat and resist oils, dirt and road contaminants. The package includes twenty stainless steel cable ties sized to secure the sleeve around pipes, hoses and wiring harnesses. Designed for automotive and light industrial use, this kit helps lower heat transfer to sensitive lines and keeps routing tidy under the hood.

How does this sleeve reduce heat exposure for fuel and brake lines?

The aluminized outer layer reflects radiant heat away while the fiberglass core provides thermal resistance, slowing heat transfer to the components inside. It shields lines from engine bay heat sources and provides a barrier against incidental oil and grease contact. This reduces temperature spikes on wrapped lines during short-term heat exposure.

• Reflective aluminum facing reduces radiant heat load.
• Fiberglass core offers thermal insulation and mechanical toughness.
• Sleeve fits over 1-1/2" I.D. lines for common fuel and brake routing.

How easy is it to install on existing hoses and wiring?

The sleeve includes an open-edge design that allows you to wrap it around installed lines without disconnecting them, and the hook-and-loop style closure (integrated along the edge) speeds positioning. Use the included stainless steel cable ties to lock the sleeve in place at clamps or near fittings. Installation is straightforward for DIYers and mechanics alike.

• Open-edge design wraps around mounted lines.
• Hook-and-loop style closure for quick alignment.
• Twenty stainless steel ties secure the sleeve at intervals and junctions.

What components can this sleeving protect in a vehicle or workshop?

This sleeving is sized and flexible enough for a wide range of systems: fuel and brake lines, intake plumbing, ignition leads, battery cables and A/C hoses. It also performs well around exhaust-adjacent wiring and sensor leads where radiant heat is a concern. The sleeve resists grime, oil and typical garage contaminants to extend the service life of protected parts.

• Fuel lines, brake lines, and intake pipes.
• Spark plug wires, battery cables, and sensor wiring.
• A/C hoses and other routed hoses near engine heat sources.

What are the temperature limits and safety considerations?

The product is heat-resistant within a working range of approximately -40°C to +160°C and demonstrates insulation performance that reduces heat transmission, but it is not fireproof. Avoid direct contact with open flames, glowing exhaust surfaces or continuous exposure above the stated maximum. Follow safe routing practices—leave clearance from red-hot components and secure the sleeve with the supplied stainless ties away from sharp edges.

• Working temperature: -40°C to +160°C; not for continuous contact above 160°C.
• Keep away from open flames and red-hot surfaces; not fireproof.
• Use included stainless steel ties and avoid sharp-edge abrasion points.

Who is this for: This LEDAUT kit suits DIY mechanics, professional technicians and hobbyists who need a reliable, installable heat barrier for wiring, hoses and small-diameter lines. It works well for automotive restorations, performance engine builds, routine under-hood maintenance and light industrial applications where reflective thermal protection and contamination resistance are required. Choose this 1-1/2" I.D. x 10ft option when you need a balance of length, diameter and secure fastening for common engine-bay runs.