LINKITOM Submersible LED Trailer Tail Lights 2-Pack — IP68 Waterproof, DOT-Compliant with Drain Hole

LINKITOM Submersible LED Boat Trailer Lights are a 2-pack, IP68-rated, DOT-compliant LED tail light set built for 12V trailers and designed to stay watertight even when submerged.

These trailer lights combine a fully welded housing, sealed circuit board and a drain-hole design to protect LEDs and electronics from moisture. Supplied as a left and right lamp with distinct functions, they replace standard incandescent units using the common 2" stud spacing and are suitable for trailers, boats, RVs and work vehicles where splash or immersion is a concern.

How do these lights keep water out when used on boats and trailers?

The LINKITOM lights use a screw-free lamp shade, welded seams and a sealed circuit board to prevent water intrusion. A small drain hole is included to channel any trapped moisture away from the LEDs and circuits. For best performance, install the lights with the drain hole pointing downward so water exits instead of pooling.

• IP68 submersible rating for short-term underwater exposure
• Welded housing and sealed PCB to block seepage
• Drain hole engineered to expel water during immersion
• Recommended orientation: drain hole facing down

What lighting functions are included and how are the left and right units different?

The set includes two complementary lamps that cover stop, turn and tail functions plus side marker and reflector duties. The left lamp adds a license plate illuminator as part of its wiring, while the right lamp is configured for stop/turn/tail and side marker/reflector only. Both are designed for a 12V electrical system and act as direct replacements for typical incandescent housings.

• Left unit: stop, turn, tail, side marker/reflector and license plate illuminator
• Right unit: stop, turn, tail and side marker/reflector
• Compatible with standard 12V trailer wiring
• Direct replacement for original incandescent lamps

Are these lights legal and easy to install on my trailer or vehicle?

Yes — the LINKITOM housings use DOT-compliant ABS materials and are manufactured to meet required safety standards for trailer lighting. Installation is straightforward: the pair mounts with two stud bolts at the industry-standard 2" spacing, matching most existing trailer holes. Always confirm wire connections and check for shorts before submerging the unit.

• DOT-compliant ABS lamp shade meets regulatory visibility standards
• 2" stud bolt spacing fits common trailer mounting points
• Simple swap-in for incandescent lamp units—no custom brackets
• Verify wiring and electrical integrity before underwater use

How durable are these lights and what vehicles can they be used on?

Built to withstand wet, salty and rough environments, these LEDs are rugged and corrosion-resistant thanks to their sealed construction. They’re widely applicable across utility and recreational vehicles that need robust rear lighting, offering long LED life and reduced maintenance compared with incandescent bulbs.

• Designed for boats, trailers, caravans, trucks, buses, vans and snowmobiles
• Sealed electronics reduce corrosion and extend lifespan
• ABS lens and welded body resist impact and vibration
• Low power draw from efficient LED arrays

Who is this for? The LINKITOM Submersible LED Boat Trailer Lights are ideal for boat owners, trailer operators, RV enthusiasts and fleet managers who need dependable, waterproof rear lighting. If you tow in wet conditions, store trailers outdoors, or require DOT-compliant replacement lights that withstand immersion and reduce maintenance, this sealed 2-pack provides a practical, plug-in upgrade to standard incandescent tail lamps.