Lippert Components Power Stabilizer Extend/ Retract Rocker Switch — IP66 Waterproof, Pre-wired Harness

Lippert's replacement extend/retract rocker switch with wiring harness restores automated control of your PSX1® power stabilizer and is built to resist water, dust, and outdoor wear with an IP66-rated sealed assembly.

When a worn or damaged switch keeps you from quickly stabilizing your trailer, this direct-replacement assembly gets your system back to working order without replacing the entire jack. Engineered for Lippert power stabilizers and compatible with many fifth-wheel RVs and travel trailers, the unit mirrors the original rocker-style control and includes the wiring harness; installation hardware is not included.

How does this switch protect against weather and campsite grime?

The switch assembly carries an IP66 rating, meaning it is designed to withstand heavy splashes and driving rain while keeping dust and debris out of the internal contacts. Its sealed housing helps preserve electrical connections and extends service life in outdoor conditions.

• IP66-rated sealed enclosure for water and dust resistance
• Corrosion-resistant contacts to reduce failure risk
• Rocker-style actuator with protective gasket to block grime

Is this easy to install on my existing Lippert stabilizer?

Yes — the replacement is made to match the original switch's form and function, so you swap it into place using your trailer's existing mounting hardware. The unit includes a pre-attached wiring harness to simplify reconnection to the stabilizer motor and controls.

• Direct-replacement shape for straightforward swap-in
• Pre-wired harness for plug-and-play reconnection
• Installation hardware not included; uses your current fasteners

Which systems and RVs is this switch compatible with?

This assembly is designed specifically for Lippert power stabilizers and Power Tongue Jacks and is compatible with PSX1® Power Stabilizers as well as many common fifth-wheel and travel trailer setups. Confirm fit by comparing the switch style and connector with your existing part.

• Intended for Lippert power stabilizer systems, including PSX1®
• Works with most fifth-wheel and travel trailer stabilizer installations
• Check connector type and mounting footprint before ordering

What functionality will I regain once the new switch is installed?

After replacement, you’ll have full extend and retract control over each stabilizer leg with the same rocker-style operation you had originally. That restores automated leveling convenience and lets the stabilizer respond to uneven ground without manual cranking.

• Full extend and retract control for automated stabilization
• Rocker operation for intuitive, instant adjustments
• Helps each leg react independently to uneven terrain

Who this is for: This replacement switch assembly is for RV owners, technicians, and DIYers who need a rugged, IP66-rated control for Lippert power stabilizers and Power Tongue Jacks. If your rocker switch is cracked, failing, or letting moisture inside the control, this sealed, pre-wired unit provides a cost-effective repair that restores automated stabilization and keeps you camping with less hassle.