NewYall ABS Wheel Speed Sensor Set for 3.6L V6 Buick/Chevy/GMC/Saturn — Front & Rear Left/Right, Direct-Fit Replacement

NewYall front and rear left/right ABS wheel speed sensors replace worn or faulty sensors on 3.6L V6 Buick Enclave, Chevrolet Traverse, GMC Acadia, and Saturn Outlook models to restore accurate wheel-speed data for your vehicle’s stability and braking systems.

These NewYall ABS wheel speed sensors are engineered specifically for 3.6L V6 applications and provide a direct-fit replacement for the factory sensors on compatible Buick, Chevrolet, GMC, and Saturn SUVs from the model years listed. They deliver the electrical signal that your ABS and traction control modules use to monitor wheel rotation. Choosing a correct-fit sensor reduces diagnostic time, minimizes false ABS warnings, and helps maintain predictable braking and stability behavior.

How do I know this sensor fits my vehicle?

Fitment is limited to vehicles equipped with the 3.6L V6 engine. Confirm your vehicle’s year and engine size before purchasing to ensure compatibility. If your vehicle matches one of the listed models and has the 3.6L V6, this sensor set is designed as a direct replacement and uses the same mounting points and connector type as the original equipment.

• Compatible models: Buick Enclave 2008–2016
• Compatible models: Chevrolet Traverse 2009–2016
• Compatible models: GMC Acadia 2007–2016
• Compatible models: Saturn Outlook 2007–2010
• Engine requirement: 3.6L V6 only — check your VIN or under-hood label

What does each sensor do and why replace them in pairs or sets?

Wheel speed sensors feed real-time rotational data to ABS, traction control, and stability systems; a failing sensor can trigger warning lights or disable certain safety features. Replacing sensors in pairs or complete sets ensures consistent signal characteristics across the axle, reducing the chance of uneven readings that can lead to unwarranted ABS events or diagnostics confusion.

• Sensors measure wheel rotation and send voltage/pulse signals to control modules
• Replacing both sides avoids mismatched signal amplitudes and timing
• New sensors cut down on false ABS/traction warnings and cleaner diagnostics

How difficult is installation and what should I inspect during replacement?

Installation is commonly straightforward for a mechanically inclined DIYer with basic tools; it typically involves removing the wheel, brake caliper or dust shield access, unbolting the sensor, and swapping connectors. During replacement, inspect the sensor mounting hole, wiring harness, and connector for corrosion, frayed insulation, or bent pins — address any harness damage to prevent future failures.

• Required tools: jack, jack stands, socket set, Torx/hex as needed, electrical contact cleaner
• Check sensor tip and mounting bore for rust or debris before installing
• Verify connector pins are clean, dry, and fully seated after installation

What should I expect electrically and during troubleshooting after install?

After installing a new sensor, ABS warning lights should clear if the sensor was the only fault and the control module has no stored adaptive errors; you may need to clear codes with a scanner. If warnings remain, test the sensor output with a multimeter or oscilloscope and inspect the tone ring or reluctor wheel for missing teeth, heavy rust, or damage that can corrupt the signal.

• Use an OBD-II scanner to confirm and clear ABS-related codes
• Measure sensor resistance or waveform per factory specs to verify operation
• Inspect reluctor ring for physical damage or excessive buildup

Who this is for: This NewYall ABS wheel speed sensor set is intended for owners, independent mechanics, and fleet technicians servicing Buick Enclave (2008–2016), Chevrolet Traverse (2009–2016), GMC Acadia (2007–2016), or Saturn Outlook (2007–2010) vehicles that use the 3.6L V6 engine. Buy this if you need a direct-fit replacement to restore consistent wheel-speed readings and simplify ABS/traction system diagnostics. If your vehicle uses a different engine, consult vehicle documentation or a VIN lookup to find the correct sensor match.