QWORK Weld-On Forged D-Ring Tie-Down Anchors 3/8" 12-Piece Set — 5,000 lb MBS, Corrosion-Resistant

QWORK 3/8" heavy-duty weld-on forged D-rings are a 12-piece set of welded-steel tie-down anchors rated to a 5,000 lb maximum breaking strength for secure cargo tie-downs on trailers, trucks, RVs, and more.

These welded forged D-rings come with matching weld-on brackets so you can install a full complement of anchor points where you need them. Built from forged steel with a welded base, each D-ring is corrosion-resistant and designed specifically for tie-down use — not for overhead lifting — with a working load limit that gives clear guidance for safe cargo restraint. The package contains twelve anchors and twelve weld-on plates, giving a balanced solution for flatbeds, utility trailers, farm equipment, docks, and workshop fixtures.

How much load can each D-ring safely handle?

Each D-ring carries a published maximum breaking strength (MBS) of 5,000 lbs and a recommended working load limit (WLL) of 1,777 lbs. Use the WLL for routine cargo restraint and never exceed it; the MBS is an absolute failure threshold measured under controlled testing conditions.

• Maximum breaking strength (MBS): 5,000 lbs
• Working load limit (WLL): 1,777 lbs
• Designed for horizontal/inline tie-down use, not overhead lifting
• Follow manufacturer and industry load-rating practices

What surfaces and vehicles are these weld-on D-rings suited for?

The welded brackets make these anchors ideal for any steel substrate where welding is appropriate: trailer frames, flatbeds, truck beds, RV chassis, farm implements, and metal docks. They’re not intended for installation on non-structural sheet metal without reinforcement.

• Trailers, flatbeds, and truck frames
• RV chassis and utility vehicles
• ATVs, farm equipment, and workshop fixtures
• Steel docks and warehouse anchor points

How are these D-rings installed and maintained for long service life?

Installation requires welding each bracket to a clean, structural steel surface by a qualified welder; ensure proper weld penetration and attachment size per local welding standards. For maintenance, inspect welds and hardware regularly, remove surface rust, and touch up protective coatings to preserve corrosion resistance and safe use.

• Weld brackets to structural steel with appropriate welding method
• Inspect welds, hardware, and D-ring integrity before each use
• Remove rust and apply protective paint or coating as needed
• Do not use for overhead lifting or beyond the listed WLL

What accessories or tie-down gear work best with these anchors?

These forged D-rings pair with a wide range of tie-down straps, chain assemblies, and bow shackles designed for transport restraint. Choose straps and hardware rated equal to or above the D-ring’s working load limit for balanced system strength.

• Ratchet straps and cam straps rated to or above 1,777 lbs WLL
• Grade-rated transport chains and load binders
• Bow or screw-pin shackles compatible with the D-ring opening
• Steel reinforcement plates for thin or non-structural mounting surfaces

Who is this for? These QWORK weld-on forged D-rings are aimed at fleet operators, trailer builders, contractors, farmers, and DIY vehicle owners who need a robust, consistent set of anchor points for cargo control. If you’re outfitting multiple attachment locations and require welded, permanent anchors rated for heavy-duty tie-down tasks, this 12-piece set offers a complete, corrosion-resistant solution. If you need removable or overhead-rated hardware instead, consider alternative lift-rated fittings and non-weld mounts suited to those uses.