Razor 24V Twist-Grip Throttle for E100/E125/E200/E300/Pocket Mod - 4-Wire Male 4-Pin OEM Replacement

Factory-original Razor 24V single-speed twist-grip throttle (4-wire, male 4-pin) designed to replace the throttle on specified Razor E100, E125, E200, E300 and Pocket Mod scooter versions.

If your Razor scooter has lost throttle response or the twist grip feels loose or erratic, this genuine Razor replacement part restores the original single-speed control behavior. It is a direct-fit factory component (Razor part # W13113601043) built to the same electrical and mechanical specifications as the throttle originally shipped with compatible scooter versions.

How do I know this throttle fits my Razor scooter?

Compatibility is version-specific rather than model-only — you must confirm the version number embedded in your scooter's serial barcode. The part works with later revisions of the E100, E125, E200, E300 and Pocket Mod models listed below.

• Check the 8-digit serial number on the battery cover barcode or underside of the frame.
• Find the two-digit version between the dashes (e.g., "10" = version 10).
• This part is for E100/E125 version 10+, E200 version 24+, E300 version 20+, and Pocket Mod version 13+.
• Do not assume visual similarity; older versions require different throttles.

What electrical and physical features does this throttle have?

This is a single-speed, 24-volt twist-grip throttle with a four-conductor male 4-pin connector for a direct plug-in installation on supported versions. It matches the OEM wiring and mounting points to keep installation straightforward for experienced DIYers or technicians.

• Factory 24V single-speed electrical design for consistent acceleration control.
• Male 4-pin connector (4-wire) compatible with matching female harness on supported scooters.
• Twist-grip form factor that replaces the original throttle housing and grip.
• Built to OEM dimensions and mounting for a secure fit without modification on compatible versions.

How do I install or replace the throttle safely?

Installation generally requires basic hand tools and a clear view of the scooter's wiring harness. Always remove power by disconnecting the battery before touching electrical connections, and follow the manual or a step-by-step guide if you’re uncertain.

• Disconnect the battery to prevent short circuits or accidental motor activation.
• Remove the handlebar cover or grip per model instructions to access the throttle assembly.
• Unplug the existing 4-pin connector and replace with the new male 4-pin throttle plug.
• Reassemble and test throttle response at low speed before full operation.

Who this part is for: owners of later-version Razor E100, E125, E200, E300 and Pocket Mod scooters who need an exact OEM-style replacement throttle. If your scooter’s version number matches the ranges above and you prefer a factory-grade part that preserves original performance and fit, this throttle is intended for you. It is not suitable for earlier-version scooters or models that use different connector types, so verify the serial/version before ordering to avoid returns or installation issues.