Spurtar Battery Quick Connect/Disconnect 2-Pack, 1/0 AWG Red — 175A, 12–36V Heavy-Duty

Spurtar 175A Battery Quick Connect/Disconnect (2-pack) is a heavy-duty 1/0 AWG inline connector set that lets you rapidly attach or remove 12–36V battery lines for winches, trolling motors, chargers, and vehicle power systems.

This two-piece quick-connect kit from Spurtar is built for high-current battery systems that require frequent connection changes. Each connector accepts 1/0 gauge (10mm²–50mm²) cable, supports up to 175 amps continuous capacity, and is rated to withstand voltages from 12 to 36 volts DC. The package includes terminal pins, dust covers, and flame-resistant boots so you can install a secure, clean, and corrosion-resistant junction for marine, off-road, or industrial battery setups.

How does this connector simplify swapping batteries or accessories?

The Spurtar connector replaces time-consuming clamp or bolt-on terminals with a quick-slide interface that locks securely under load. It eliminates fumbling with tools during service and creates a repeatable contact that’s easier to handle in tight or dirty environments.

• Push-fit connection with positive locking action for fast changes
• Dust covers and anti-flame boots keep contacts clean when disconnected
• Compatible with jumper leads, winch cables, chargers, and trolling motors
• No male/female confusion—terminals insert and lock inside the housing

What wiring and electrical specs should I expect for safe installation?

This kit is sized for 1/0 AWG wiring and rated at 175 amps continuous, making it suitable for many medium- and high-current battery circuits. The connectors handle typical 12–36V DC systems and are designed for crimp or solder termination of the included copper pins.

• Wire gauge supported: 1/0 AWG (10mm²–50mm²)
• Current capacity: 175 A nominal
• Voltage range: 12–36 V DC (withstanding up to 600 V insulation level)
• Termination options: crimp or solder copper contacts

Will these connectors resist corrosion and debris in outdoor use?

Spurtar designed the kit for rugged environments: the contacts are corrosion-resistant copper and the housings include flame-resistant boots and dust caps. Those features help maintain reliable conductivity when used on boats, tow rigs, or outdoor equipment.

• Four copper contact pins that resist oxidation
• Hard anti-flame boot caps for protection against dirt and sparks
• Dust covers included to prevent moisture and grime buildup
• Secure locking inside the housing minimizes exposed metal

Who is this for: Technicians, boat owners, off-road enthusiasts, and fleet mechanics who need a durable, serviceable quick-disconnect for medium- to high-current battery systems. If you swap batteries or accessories often—trolling motors, winches, chargers, pallet forks, or auxiliary systems—this Spurtar 175A 1/0 AWG connector kit gives a tidy, repeatable connection while protecting contacts from environmental wear. It’s also a practical addition to a jumper-cable kit or onboard charging setup where quick, safe removal of power is required.