YM E-Bright LED Hood Light Strip — 94in White Dynamic Scan DRL, IP68 Waterproof

YM E-Bright's 94-inch Dynamic Scan Hood Light Strip is a flexible, waterproof white LED strip that mounts under a car hood to provide a sweeping startup animation and steady daytime running illumination for 12V vehicles.

This high‑visibility hood beam from YM E-Bright combines a dramatic dynamic scan startup effect with continuous driving illumination in a single, low‑profile strip. Built to resist water and to be trimmed to fit, the 94‑inch (240 cm) strip suits cars, trucks, SUVs and boats that have enough clearance under the hood. It’s designed to increase vehicle visibility after startup and provide accent lighting while driving, with integrated short‑circuit protection and heavy‑duty adhesive for secure mounting.

How does the dynamic scan startup work and what does it look like?

When the vehicle powers on, the LED strip plays a running light sequence that travels along the strip for a few seconds before switching to steady illumination. The animated startup is eye‑catching and signals vehicle presence to pedestrians and other drivers without requiring separate controllers.

• Automatic run‑through animation on ignition.
• Then reverts to constant white DRL while driving.
• Visible sweep effect designed for hood or grille mounting.
• No external controller needed for the startup sequence.

Is the 94-inch strip safe to install on my car and how is it weatherproofed?

The strip is encased in soft silicone and rated IP68, offering strong resistance to water and road spray. It includes short‑circuit protection and heavy adhesive tape on both sides to minimize movement; however, the manufacturer warns against using high‑pressure water directly on the strip during car washing.

• IP68 silicone housing for dust and water protection.
• Short circuit/fuse protection built into wiring for safety.
• Strong nano tape secures the strip to engine cover or grille.
• Avoid direct high‑pressure water streams when cleaning the area.

Can I cut the strip to fit my vehicle and what should I watch for?

The YM E-Bright hood strip can be trimmed at marked cut lines to shorten its length to fit your vehicle, but doing so may shift where the dynamic scanning points begin. After cutting, seal the end properly to retain waterproofing and check wiring for correct polarity to avoid flicker or partial outages.

• Cut only at the printed black cutting marks.
• Sealing the cut end is necessary to keep IP68 performance.
• Cutting changes scan sequencing placement.
• If LEDs flicker, verify wiring and seal; contact support for defects.

How do I wire and mount this hood light strip?

Installation is straightforward: connect the black lead to chassis ground and the red lead to an ACC (accessory) fused circuit so the strip powers with ignition. The package includes a hot glue stick, test probe and instructions to help position, secure and test the strip before final mounting.

• Black wire to negative/ground; red wire to ACC fuse.
• Use included hot glue and heavy nano tape for firm attachment.
• Check fuse box with test probe to locate ACC circuit.
• Confirm hood clearance (0.8 cm / 0.31 in thickness) before mounting.

Who is this for: The YM E-Bright 94in Dynamic Scan Hood Light Strip is ideal for vehicle owners who want bold, low‑profile accent lighting and a dynamic startup effect on 12V cars, trucks, SUVs and boats. It suits DIY installers comfortable trimming and wiring LED strips, and anyone seeking improved visible presence at night or a distinctive aesthetic under their hood or grille. If your hood gap is smaller than about 0.8 cm (0.31 in), this model may not fit safely—measure first to avoid damage when closing the hood.